Range Rover Evoque manuals

Range Rover Evoque: Rear seat access (coupe models)

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Front seats / Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch.

1. Lift the locking lever and pivot the seatback

1. Lift the locking lever and pivot the seatback forwards.

2. Press the front of the switch to power the seat forwards.

3. To return the seat, pivot the seatback until it locks into its previous position, then press and hold the rear of the switch to power the seat rearwards until it locks into position.

READ NEXT:

 Rear seats

 Folding and raising the rear seats

Folding and raising the rear seats The split fold rear seat of 5 door models can be folded completely, or partially at 60/40 split, to accommodate loads and still retain seating for passengers.

 Rear seat head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the

SEE MORE:

 Climate Control Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. CAUTION: LH illustration shown, RH is similar. NOTE: The procedure must be carried out on both sides. Torque: 1.9 Nm Vehicles with manual transmission 2. Refer to: Gearshift Lever Knob (308-06 Manual T

 Drive Pinion Front Bearing

Special Tool(s) 100-012 Slide Hammer 205-067 Preload Gauge 308-615 Remover, Seals JLR-205-972 Mounting Bracket, Rear Axle JLR-205-984 Remover/Installer, Drive Pinion Nut JLR-205-985 Remover, Drive Pinion Bearing JLR-205-986 Installer, Drive Pinion Bearing Removal 1. Raise and support the vehicle. 2.

© 2011-2025 Copyright www.rrevoque.org