Range Rover Evoque: Rear Seat Cushion Cover

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Prior to carrying out the step by step procedure below, Steps 2 and 3 must be followed for knowledge on how to correctly install and care for the seat cover.

2.

Range Rover Evoque. Rear Seat Cushion Cover

3.

Range Rover Evoque. Rear Seat Cushion Cover

4. If required, follow the steps below to carry out the removal and installation procedure.

5. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).

6.

Range Rover Evoque. Rear Seat Cushion Cover

7. NOTE: Make sure that new hog rings are installed.

Range Rover Evoque. Rear Seat Cushion Cover

Installation

1. NOTES:

If a replacement rear seat backrest cover is to be installed, cut out holes for the head restraint guide tubes and center safety belt trim panel. Use the existing rear seat backrest cover as a template. This also applies to the backrest squab foam.

Use hog ring pliers to close the hog rings. Do not use any other tool. The hog rings must be closed to overlap as illustrated.

Make sure that new hog rings are installed.

Range Rover Evoque. Rear Seat Cushion Cover

2. NOTE: Make sure that the hogrings are installed in the sequence shown.

Range Rover Evoque. Rear Seat Cushion Cover

3. NOTE: Make sure that the hogrings are installed in the sequence shown.

Range Rover Evoque. Rear Seat Cushion Cover

4. To install, reverse the removal procedure.

READ NEXT:

 Front Seat Backrest Heater Mat

Removal WARNINGS: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS)

 Rear Seat Backrest Cover 3-Door

Removal NOTES: This procedure covers the removal and installation of both rear seat backrests and the LH rear seat backrest cover. The RH rear seat backrest cover is similar. All notes and cautions

 Front Seat Track

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Spe

SEE MORE:

 Rear Inner Quarter Panel

Removal NOTES: The rear inner quarter panel is manufactured from mild steel. The rear inner quarter panel is unpicked from the inner quarter panel, it is not serviced separately. There are NVH components on this panel, they are not serviced on the new panel. If damaged, new components will be re

 How To Use This Manual

How To Use This Manual This manual covers all aspects necessary in order to service the vehicle effectively. The manual is structured into five main sections, General Information, Chassis, Powertrain, Electrical and Body and Paint with each section dealing with a specific part of a vehicle system

© 2011-2026 Copyright www.rrevoque.org