Range Rover Evoque: Rear Wheel Bearing
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Rear Wheel Bearing
JLR-204-810
Installer, Rear Wheel Bearing
General Equipment
- Copper Hammer
- Hydraulic press
- Punch
- Vise
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel Knuckle (204-02 Rear Suspension, Removal and Installation).
3.
- Special Tool(s): JLR-204-806
- Special Tool(s): 204-726
- General Equipment: Hydraulic press
4.
- General Equipment: Vise
- General Equipment: Copper Hammer
- General Equipment: Punch
5.
- Special Tool(s): 204-305
- General Equipment: Hydraulic press
6. Clean all the mating faces and reusable parts thoroughly and check for damage.
7.
8. NOTE: Note the orientation of the component prior to removal.
- Special Tool(s): 204-250
- General Equipment: Hydraulic press
Installation
1. CAUTION: Make sure that the area around the component is clean and free of foreign material.
Special Tool(s): JLR-204-809
2. NOTE: Make sure that the component is installed to the noted removal position.
- Special Tool(s): JLR-204-810
- General Equipment: Hydraulic press
3.
4.
- Special Tool(s): 204-726
- General Equipment: Hydraulic press
5. Refer to: Wheel Knuckle (204-02 Rear Suspension, Removal and Installation).
READ NEXT:
Front Lower Arm
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Front wheel drive transmission illustrations shown, all wheel wheel drive
transmission
Rear Lower Arm AWD
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTION: LH illustration shown, RH is similar.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
Rear Stabilizer Bar
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
SEE MORE:
Towing eyes
The towing eyes at the front
and rear
of the vehicle are designed for
on-road recovery only. If they are used
for any other purpose, it may result in
vehicle damage and serious injury.
The towing eyes are located behind panels in
the bumpers. Panel design will vary depending
on the vehic
Rds-tmc display
When a TMC signal is received the icon in the
top left of the screen will appear green. If a TMC
signal is not being received, the icon will be
shown with a bar through it.
The system will inform the driver of any
reported roadworks, narrow road, contraflow,
accidents, slippery road, diversion
