Range Rover Evoque: Replacing remote control batteries

Replacing remote control batteries
With the back of the remote control facing
upwards, use a coin or similar implement to
rotate the battery cover. Lift the cover off to
reveal the battery compartment. Remove the
old battery and, ensuring that the correct
polarity is maintained, insert a replacement 3.3
volt, CR1/3N battery. Replace the cover and
rotate it to lock it closed.
READ NEXT:
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle.
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or u
SEE MORE:
Component Location
NOTE: RHD (right-hand drive) installations shown; LHD (left-hand drive)
installations similar.
COMPONENT LOCATION - SHEET 1 OF 2
RH (right-hand) front wheel speed sensor
RH rear wheel speed sensor
LH (left-hand) rear wheel speed sensor
LH front wheel speed sensor
Integrate
Component Location
NOTE: Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar
COMPONENT LOCATION
Passenger face level/side window register
Side window vent
Face level duct
Side window duct
Windshield duct
Windshield vent
Side window vent
Driver face level/side window register
Drive
© 2011-2026 Copyright www.rrevoque.org
