Range Rover Evoque: Speed Control
Speed Control Actuator
Removal
1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
Installation
1. To install, reverse the removal procedure.
Speed Control Deactivator Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: LH illustration shown, RH is similar.
2.
Installation
1. To install, reverse the removal procedure.
Speed Control Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the air bag supplemental restraint system (SRS) safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).
4. Torque: 1.3 Nm
5. CAUTION: Take extra care not to damage the edges of the component.
Torque: 2.1 Nm
6. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Climate Control System - General Information
Climate Control
Lubricants, Fluids, Sealers and Adhesives
General Specification
Capacities
Refrigerant oil adding capacities for replacment parts
NOTE: Rotate the A/C compressor shaft at least 6 t
SEE MORE:
Windshield Glass
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Lay the glass on felt covered supports. Do not stand on edge as this can cause
chips which subsequently develop
into cracks.
NOTES:
The cutting
Airbag warning lamp
Airbag warning lamp
The airbag warning lamp is
mounted in the instrument pack
and will illuminate as a bulb check
when the ignition is turned on.
If the warning lamp indicates
that a
fault is present in the system, do not
use a child restraint on the front
passenger seat.
If any of the
