Range Rover Evoque: Topping up the coolant

when the Never remove the filler cap when the engine is hot - escaping steam or scalding water could cause serious personal injury.
Antifreeze is highly inflammable. Do not allow antifreeze to come into contact with naked flames or other sources of ignition (e.g. a hot engine) - a fire may result.
Unscrew the filler cap slowly, allowing the pressure to escape before removing completely.

territories where the When travelling in territories where the water supply contains salt, always ensure you carry a supply of fresh (rain or distilled) water. Topping up with salt water will cause serious engine damage.

Top-up to the MAX indicator mark on the side of the expansion tank. Use only a 50% mix of water and Texaco XLC antifreeze.

Note: In an emergency - and only if the approved antifreeze is unavailable - top-up the cooling system with clean water, but be aware of the resultant reduction in frost protection.

Do not top-up or refill with conventional antifreeze formulations. If in doubt consult a qualified technician.

Ensure the cap is tightened fully after top-up is completed by turning the cap until the ratchet cap clicks.

READ NEXT:

 Coolant antifreeze

Antifreeze is poisonous and can be fatal if swallowed - keep containers sealed and out of the reach of children. If accidental consumption is suspected, seek medical attention immediately. If

 Brake/clutch fluid check

Seek qualified assistance immediately if brake pedal travel is unusually long or if there is any significant loss of brake fluid. Driving under such conditions could result in extended stopping

 Topping up the brake/clutch fluid

Brake fluid will damage painted surfaces. Soak up any spillage with an absorbent cloth immediately and wash the area with a mixture of car shampoo and water. Only use new fluid from an airtigh

SEE MORE:

 Steering Gear

Special Tool(s) 205-754A Splitter, Ball Joints 502-012 Alignment Pins, Subframe General Equipment Transmission jack Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: Removal steps in this procedure may contain installation details. LHD il

 Rear Suspension FWD

Component Location Stabilizer link RH (right-hand) spring and damper assembly Stabilizer bar LH (left-hand) spring and damper assembly Wheel knuckle Stub axle and locknut Hub Longitudinal link Rear transverse link Front transverse link Front Wheel Drive (FWD) Rear Subframe Overview The

© 2011-2026 Copyright www.rrevoque.org