Range Rover Evoque: Trailer electrical connection
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Towing / Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer.
When a trailer electrical connection is made and the vehicle’s direction indicators are used, the trailer warning indicator will flash in time with the direction indicators.
READ NEXT:
Powered tailgate
When towing, ensure there is
sufficient
clearance before opening or closing the
tailgate.
Parking aids
The rear parking aids sensors are automatically
disabled when a trailer with an approved
electrical connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking
Trailer stability assist (TSA)
When a trailer is attached, TSA will
automatically detect when a trailer sway is
developing. It will then gradually reduce vehicle
speed by cutting engine power and applying
the brakes to help reg
SEE MORE:
Catalyst Monitor Sensor
Special Tool(s)
310-121
Wrench, H02S
Removal
WARNING: Observe due care when working near a hot exhaust system.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the batt
Solvents, Sealants and Adhesives
Solvents
WARNING: Always
handle all solvents, sealers and adhesives with extreme care. Some contain
chemicals or give off
fumes which can be dangerous to health. Always follow the manufacturers
instructions. If in doubt about any substance,
particularly a solvent, DO NOT use it.
CAUTION: If in
© 2011-2025 Copyright www.rrevoque.org
