Range Rover Evoque: Warning lamps

RED warning lamps are for primary warnings.

A primary warning must be investigated immediately.

Seek qualified assistance before continuing.

AMBER and YELLOW warning lamps are for secondary warnings. Some indicate that a vehicle system is in operation, others indicate that the driver must take action and then seek qualified assistance as soon as possible GREEN and BLUE lamps within the instrument panel indicate system status, such as green for direction indicators, when in operation and blue for high beam.

READ NEXT:

 Bulb check

A warning lamp bulb check is initiated when the ignition system is switched on and lasts for 3 seconds (except for the airbag warning lamp which will remain on for 6 seconds). If any warning lamp

 Critical warning message (red)

Critical warning message (red) Illuminates when a critical warning message is available in the message centre.

 Low oil pressure (red)

Low oil pressure (red) Illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp remains on, flashes or illuminates while driving, stop the v

SEE MORE:

 Wiring Harness - Description and Operation

Introduction CAUTION: Do not use any other heat shrink sleeve other than the approved glue lined heat shrink sleeve mentioned in the repair procedure. The purpose of this document is to promote quick and efficient minor repair to harness connectors or cables using approved methods and the wiring

 Touch Screen (TS)

Touch Screen Display (FCDIM) The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Multifunction Display Module, for additional Diagnosis and Testing information refer to the relevant Diagnosis and Testing Section. For additional information, refer to: Information

© 2011-2025 Copyright www.rrevoque.org