Range Rover Evoque: Anti-Lock Control - Stability Assist

Accelerometer

Removal

NOTES:

Removal steps in this procedure may contain installation details.

LHD illustration shown, RHD is similar.

Vehicles with automatic transmission

1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

2. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Vehicles with manual transmission

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4.

Range Rover Evoque. Anti-Lock Control - Stability Assist

5.

Range Rover Evoque. Anti-Lock Control - Stability Assist

6. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Steering System

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

SEE MORE:

 Unlocking the vehicle

To prevent accidental operation, never leave the Smart Key in the vehicle if children or animals are also left in the vehicle. Note: The operational range of the Smart Key will vary considerably depending on atmospheric conditions and interference from other transmitting devices. Note:

 Fuel Fired Booster Heater FWD

Component Location COMPONENT LOCATION - VEHICLES WITHOUT FFBH REMOTE CONTROL ATC (automatic temperature control) module Fuel Fired Booster Heater (FFBH) Auxiliary coolant pump Ambient air temperature sensor Auxiliary fuel pump COMPONENT LOCATION - VEHICLES WITH FFBH REMOTE CONTROL ATC mod

© 2011-2026 Copyright www.rrevoque.org