Range Rover Evoque: Beltminder
A front and rear seat Beltminder system warns the driver when the seat belt of an occupied seat is not fastened or is unfastened during a journey.
Beltminder
A graphic accompanied by a text message in the message centre indicates which seat belts are fastened at the start of a journey and also when a seat belt is fastened or unfastened during a journey.
Each seating position is represented by a passenger icon, the colour of which indicates the seat belt status: - Green - seat belt in the indicated position is fastened.
- Red - seat belt in the indicated position has been unfastened while the vehicle ignition is on. This indicator will turn grey after 30 seconds.
- Grey - seat belt not fastened.
Note: The indicators will be displayed for 30 seconds each time there is a status change, e.g., a seat belt is unfastened or fastened or a door is opened and then closed.
In addition, an audible warning will sound under the following conditions: - The seat belt of an occupied front seat is not fastened or is unfastened during a journey.
- A rear seat belt is unfastened.
Note: If a heavy object is placed on the front passenger seat, it may activate the Beltminder feature. It is recommended that any objects placed on the front passenger seat are secured using the seat belt.
READ NEXT:
Child seats
For optimum
safety, children should
travel in the rear of the vehicle at all
times; front passenger seat travel is
not recommended. However, if it is
essential that a child travels in the
fron
Child seat positioning
Crash statistics show that
children are
safest when properly restrained in a
child or infant restraint system that is
secured in a rear seating position.
Information given within the
table i
Recommended child seats
Recommended child seats
SEE MORE:
Epb automatic use
EPB will be applied automatically if the ignition
is switched off and the vehicle speed is below
3km/h (2mph).
To prevent automatic operation, when the
vehicle is stationary, press and hold the EPB
switch in the release position. Within 5
seconds, switch off the ignition and continue to
hold
Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly
aligned, it must be placed on an approved alignment
jig.
2. The rear bumper mounting is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
3.
