Range Rover Evoque: Bulb check
A warning lamp bulb check is initiated when the ignition system is switched on and lasts for 3 seconds (except for the airbag warning lamp which will remain on for 6 seconds). If any warning lamp remains on after this period, investigate the cause before driving.
Some warning lamps have associated messages displayed on the message centre.
Note: Not all warning lamps are included in the check (e.g. high beam headlamps and direction indicators).
READ NEXT:
Critical warning message (red)
Critical warning message (red)
Illuminates when a critical warning
message is available in the
message centre.
Low oil pressure (red)
Low oil pressure (red)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp remains on, flashes or
illuminates while driving, stop the v
Brake systems (red)
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution
SEE MORE:
Rear View
Mirror
Headlamp Control Module B (HCMB)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault and may also cause additional faults in
the vehicle being checked and/or the donor
vehicle.
NOTES:
If
Front Side Member Section
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member section is cut from the front side member and is
manufactured from RP260.
This procedure is written for the LH front side member section replacement, the
LH and RH front side member sections differ i
© 2011-2026 Copyright www.rrevoque.org
