Range Rover Evoque: Bulb specification chart
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Technical specifications / Bulb specification chart
Before attempting to replace
a bulb,
ensure that both the affected lamp and
the vehicle's ignition, are turned off. If
the circuit remains live, a short circuit
can occur which may damage the
vehicle's electrical system.
Note: LED bulbs can be replaced only by a Land Rover Dealer/Authorised Repairer.
READ NEXT:
Smart key system transmitters
1. Steering column backup transmitter.
2. Front cockpit transmitters.
3. Front exterior door handle transmitters.
4. Roof keyless receiver.
5. Floor console front transmitter.
6. Rear exterior
SEE MORE:
Transfer Case
Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: M66 6-Speed
Manual Transmission AWD
Special Tool(s)
100-012
Slide Hammer
303-1300
Remover, Crankshaft Seal
303-538
Remover/Installer, Crankshaft Oil Seal
307-594
Installer, Seal
307-595
Installer, Intermediate Shaft Seal
308-615
Remover, Seals
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information
Anti-Lock Control
Torque Specifications
Anti-Lock Brake System (ABS) Module
Removal
CAUTIONS:
If brake fluid is spilt on the paintwork, the affected area must be
immediately washed down with cold water.
Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contai
© 2011-2025 Copyright www.rrevoque.org
