Range Rover Evoque: Catalyst Monitor Sensor
Special Tool(s)
310-121
Wrench, H02S
Removal
WARNING: Observe due care when working near a hot exhaust system.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).
4.
5.
6. Torque:
- M6 10 Nm
- M10 45 Nm
7.
8. CAUTIONS:
Make sure that the mating faces are clean and free of corrosion and foreign material.
Note the fitted position of the component prior to removal.
Special Tool(s): 310-121
Torque: 48 Nm
Installation
1. CAUTIONS:
If accidentally dropped or knocked install a new sensor.
Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
Make sure the anti-seize compound does not contact the heated oxygen sensor (HO2S) tip.
NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
To install, reverse the removal procedure.
Front Knock Sensor (KS)
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Intake Manifold (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
3. CAUTION: Note the fitted position of the component prior to removal.
NOTE: Make sure that the component is installed to the noted removal position.
Torque: 20 Nm
Installation
1. To install, reverse the removal procedure.
Rear Knock Sensor (KS)
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Intake Manifold (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
3. CAUTION: Note the fitted position of the component prior to removal.
NOTE: Make sure that the component is installed to the noted removal position. Torque: 20 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Electronic Engine Controls
Principles of Operation
For a detailed description of the 2.0L GTDi petrol electronic engine
controls, refer to the relevant Description and Operation
section in the workshop manual. REFER to: (303-1
SEE MORE:
Identification Codes
VIN Number
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
The body VIN is located behind the spare wheel well under the rear carpet.
Windscreen VIN - UK, Europe and ROW
Windscreen VIN - China only
VIN label - UK, Europe and ROW
Type/
Double locking
Never double lock the vehicle
with
people, children, or pets inside. In the
event of an emergency they would be
unable to escape and the emergency
services would be unable to release
them quickly.
Double locking secures the vehicle and
prevents the doors being opened from inside
or outsid
