Range Rover Evoque: Central Junction Box (CJB)
Removal
CAUTIONS:
If a new component is to be installed, the Land Rover approved diagnostic equipment must be connected prior to removal, the data must then be downloaded from it and the keys (remote control handsets) set into default mode. Failure to follow this instruction will result in permanent damage to the keys.
A maximum of 4 remote transmitters can be programmed to the anti-theft alarm and double locking module.
Programming for all remote transmitters must be carried out at the same time.
NOTES: Removal steps in this procedure may contain installation details.
Make sure that all keys (remote control handsets) are present when performing this procedure.
1. If a new Central Junction Box (CJB) is to be installed, use Land Rover approved equipment to upload the stored data.
2. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).
4.
5.
6.
7.
8. Torque: 8 Nm
9.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Battery Junction Box (BJB) TD4 2.2L
Diesel
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. Refer
Battery Junction Box (BJB) GTDi 2.0L
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. Refer
Communications Network - Overview, System
Operation and Component Description
Overview
A number of different types of communication networks are incorporated into
the vehicle wiring harnesses for the
transmission of commands and information between control modules. The
config
SEE MORE:
Active
On-demand Coupling Control Module
Rear Differential Control Module (RDCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOT
Instrument panel,touch screen and audio system
Do not use upholstery cleaner
on
electrical equipment such as fascia
switches.
When cleaning around electrical
equipment such as switches, ensure
that fluids do not leak into any gaps
around the components or between
panels or trim.
- Clean with a lightly moistened cloth.
- Do not use ch
