Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Before programming

When programming a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure. For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other devic

 Changing the connected phone

Up to 10 mobile phones can be paired with the vehicle in the same way. However, only one can be connected and ready for use as a phone at any one time. To connect a different paired phone, follow the steps below: 1. From the Home menu, select Phone. 2. A menu will appear. Select Change phone.

© 2011-2025 Copyright www.rrevoque.org