Range Rover Evoque manuals

Range Rover Evoque: Dynamic stability control (DSC)

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control / Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs.

for The vehicle is not designed for cornering at the same speed as conventional passenger cars any more than a low-slung sports car is designed to perform satisfactorily under off-road conditions. If at all possible, avoid sharp turns or abrupt manoeuvres. As with other vehicles of this type, failure to operate the vehicle correctly may result in loss of control or vehicle rollover.

READ NEXT:

 Dsc warning lamp

The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC

 Disabling dsc

Safety may be reduced by inappropriately disabling DSC. In the majority of driving situations, and particularly on-road, it is recommended that you do not disable DSC. In some driving condition

 Re-enabling dsc

DSC is re-enabled by one of the following: - Press and briefly hold the DSC OFF switch. - Stop and restart the engine. - Select a new Terrain Response special program.

SEE MORE:

 Leather

Use only cleaning products specifically designed for use on leather. Do not use solvents. Do not use chemical, alcohol, or abrasive materials, as they will cause rapid deterioration of the leather. The use of products which are not approved will invalidate your warranty. If you are in any

 Control Diagram, System Operation

Control Diagram NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect Network (LIN) Bus CONTROL DIAGRAM - SHEET 1 OF 2 Battery Starter motor fuse Battery Junction Box (BJB) Starter motor Generator Transmission Control Module (TCM) Cooling fan control module Air Conditioning

© 2011-2026 Copyright www.rrevoque.org