Range Rover Evoque: Front Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Torque: 6 Nm

2. Torque: 6 Nm

3. Torque: 0.9 Nm

4. Torque: 1.3 Nm

5-door
5.

3-door
6.

All vehicles
7.

8.

9. NOTE: Do not disassemble further if the
component is removed for access only.

10.

11.

12. Torque: 1 Nm

13. NOTE: Where fitted.
Torque: 1 Nm

14. NOTE: Where fitted.
Torque: 1 Nm

Installation
1. To install, reverse the removal procedure.
READ NEXT:
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Vehicles with glass roof panel shown, vehicles without glass roof panel similar.
All vehicles
1. Refer to: Windshield
Engine Cover GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Do not disassemble further if the
component is removed for access only.
Inst
SEE MORE:
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
Remove the spare wheel prior
to
jacking the vehicle, to avoid
destabilising the vehicle when raised.
Do not use power tools to
loosen the
spare wheel. Doing so may damage the
mechanism.
1. To access the temporary spare wheel, fold
forward the rear edge of the cover then
remove it.
2.
© 2011-2026 Copyright www.rrevoque.org
