Range Rover Evoque: Headlamp Adjustment
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles have vertical adjustment only.
- Adjust the headlamps with an Allen Key.
- Rotate the adjuster 'A' for horizontal alignment.
- Rotate the adjuster 'B' for vertical alignment.
4.
- To adjust the second headlamp, repeat the above procedure.
Front Fog Lamp Adjustment
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
1. NOTE: The fog lamp beam should be set at 2% below the horizontal and parallel. Check the fog lamp beam alignment.
2. Align the beam setting equipment 2. to one fog lamp.
3.
4. Adjust the fog lamp.
5. To adjust the second fog lamp, repeat the above procedure.
Front Fog Lamp LH
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Remove the LH front wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. CAUTION: Take extra care not to damage the component.
4.
5. NOTE: RH illustration shown, LH is similar.
Torque: 2 Nm
Installation
1. To install, reverse the removal procedure.
2. Check the fog lamp beam alignment.
Refer to: Front Fog Lamp Adjustment (417-01 Exterior Lighting, General Procedures).
READ NEXT:
Headlamp Assembly
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
3.
4. NOTE: Some com
Headlamps
Principle of Operation
Three types of headlamp are available: Halogen, bi-xenon or Adaptive Front
Lighting System (AFS).
For a detailed description of the headlamps operation, refer to the relevant
Stoplamps
Principle of Operation
For information on the description and operation of the system, refer to
relevant section of the workshop manual. REFER
to: (417-01 Exterior Lighting)
Note that the stoplamps w
SEE MORE:
Inner Back Panel Assembly
Removal
NOTES:
The inner back panel assembly is manufactured from mild steel.
The panel is serviced less its weld studs.
The new service panel is not fully spot welded when supplied.
It is necessary to remove a section of one rear lamp mounting panel to enable
removal and installation of the inn
Information and Message Center
Information and Message Center -
Component Location
COMPONENT LOCATION
Information and Message Center -
Overview
OVERVIEW
The message center is located in the instrument cluster, in a central
position between speedometer and the tachometer.
The 5 inch Thin Film Transistor (TFT) display can be cont
