Range Rover Evoque: Lumbar Assembly Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Side Air Bag Module - Vehicles With: Sports Seats (501-20B Supplemental Restraint System, Removal and Installation).
4.
5.
6.
7.
Installation
1. To install, reverse the removal procedure.
Front Seat Tilt Assembly Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Side Air Bag Module - Vehicles With: Sports Seats (501-20B Supplemental Restraint System, Removal and Installation).
4.
5.
6. NOTE: Repeat the procedure for the other side.
7.
8.
9.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Front Seat Cushion Cover Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on
Driver Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
Passenger Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Spe
SEE MORE:
Spare Wheel Well
Removal
NOTES:
The spare wheel well is manufactured from mild steel, it includes the
spare wheel retaining bracket.
The panel is serviced less its weld studs
1. The spare wheel well is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
Rear bumper mounting LH & RH
Rea
Control Diagram
NOTES:
A = Hardwired; N = Medium Speed CAN (controller area network) bus; D =
High Speed CAN bus; T = Coaxial; O =
LIN (local interconnect network) bus; P = Fibre Optic MOST; AD = NSTC; AE = LVDS;
Park assist is not available to all markets.
CONTROL DIAGRAM - SHEET 1 OF 3 - PARKING AID AND PARK ASS
