Range Rover Evoque: Reprogramming a single garage door opener button
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Reprogramming a single garage door opener button
To programme a device to a previously programmed button: 1. Press and hold the desired pre-programmed HomeLink button for at least 20 seconds, but no longer than 30 seconds, until the indicator lamp begins to flash.
2. Without releasing the button, position the hand-held transmitter approximately 50 to 150 mm (2 to 6 inches) away from the HomeLink transceiver, keeping the indicator lamp in view.
3. Carry out Step 3 of Programming.
READ NEXT:
To erase all programming
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
SEE MORE:
Transmission Control Module (TCM) GTDi 2.0L
Petrol
Removal
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Air Cleaner (303-12A Intake Air Distribution and Filtering -
TD4 2.2L Diesel, Removal and Installation).
3.
4.
5. CAUTION: Discard the component.
6.
7.
Rain sensor
Ensure that the wipers are
switched off
before entering a car wash. If the rain
sensitive wipers operate during the car
washing process, damage may occur to
the wiper mechanism.
The rain sensor is able to detect the presence
and amount of rain/dirt/snow on the
windscreen and automatically
© 2011-2026 Copyright www.rrevoque.org
