Range Rover Evoque: Selecting valet mode
Valet mode allows the vehicle to be driven, e.g.,
by a parking attendant, but leaves the tailgate
locked and restricts use of the touch screen.
This prevents access to telephone numbers,
navigation addresses and audio system
settings.
From the Home menu, select Valet:
Enter a four digit Personal identification
Number (PIN) (personally chosen). On
completion, touch the OK soft key.
If you wish to cancel the PIN, select Delete.
After entering the PIN, you will be prompted to
enter the PIN again. Enter the same PIN and
touch OK to confirm.
A pop-up screen is displayed, confirming your
vehicle is now in Valet mode.
READ NEXT:
The interior protection feature of the full alarm
system may be temporarily disabled via Alarm
sensors in the Vehicle Settings menu. See 56,
VEHICLE INFORMATION AND SETTINGS
MENU.
Note: If the in
In certain markets, a battery backed sounder is
fitted. This device will sound if it or the vehicle
battery is disconnected while the security
system is armed.
The tilt sensor detects any change to the
vehicle’s angle to the ground. When the alarm
is armed and the vehicle is double locked, any
change in the vehicle’s angle will activate the
tilt alar
SEE MORE:
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep the buttons pressed until the
indicator lamp begins to flash (this will take
approximately 20 second
Special Tool(s)
100-012
Slide Hammer
205-871
Installer, Transfer Case Rear Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
© 2011-2025 Copyright www.rrevoque.org
