Range Rover Evoque: Side Air Curtain Module
Removal
CAUTION: Do not allow the side air curtain module to twist. Failure to follow this instruction may result in damage to the component.
NOTES:
Removal steps in this procedure may contain installation details.
RH illustration shown, LH is similar.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Headliner (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. Torque: 10 Nm
5. Torque: 10 Nm
6. CAUTION: Take extra care not to damage the wiring harnesses.
7. CAUTIONS:
Take extra care not to damage the component.
Note the fitted position of the component prior to removal.
NOTE: Make sure that the component is installed to the position noted on removal.
Torque: 10 Nm
Installation
1. NOTE: If the original component is to be installed, then the washers on the retaining bolts will require loosening to aid the location of the retaining hooks. If a new component is being installed this instruction will not be required.
2. To install, reverse the removal procedure.
3. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
READ NEXT:
Clockspring
Removal
CAUTION: Make sure that the road wheels are in the straight ahead
position.
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: St
Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS)
Principle of Operation
For a detailed description of the supplemental restraints system and
operation, refer to the relevant Description and
Operation section in the workshop manual. REFER to: (501-2
Side Air Bag Module Vehicles With: Sports
Seats
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
SEE MORE:
Warning lamps
RED warning lamps are for primary warnings.
A primary warning must be investigated
immediately.
Seek qualified assistance before continuing.
AMBER and YELLOW warning lamps are for
secondary warnings. Some indicate that a
vehicle system is in operation, others indicate
that the driver must tak
High beam assist
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only active when the ambient light drops below
a predetermined level.
Note: It is not recommended that high
