Range Rover Evoque: Switching on the ignition
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching on the ignition
To turn on the ignition without starting the
engine:
- Do not depress the brake/clutch pedal,
- Press the START/STOP button and hold
until the warning lamps illuminate, then
release the button.
If the brake/clutch pedal is
applied when
the start/stop button is pressed, the
engine will start.
READ NEXT:
Engine starting
Never start the engine, or
leave it
running, when the vehicle is in an
enclosed space. Exhaust gasses are
poisonous and can cause
unconsciousness and death if inhaled.
If the engine fails to
Engine starting: automatic transmission
1. A valid Smart Key must be inside the
vehicle.
2. Make sure the gear selector is in P or N.
3. Firmly depress the brake pedal.
4. Press and release the start button. The
engine will crank autom
Engine starting: manual transmission
Note: Do not press the accelerator pedal when
starting the engine.
1. A valid Smart Key must be inside the
vehicle.
2. Fully depress the clutch pedal.
3. Press and release the start button. For
SEE MORE:
Anti-Theft - Active
Anti-Theft - Active - Component Location
COMPONENT LOCATION
RH (right-hand) front door module
RH front door latch mechanism
Radio Frequency (RF) receiver
RH rear door module
RH rear door latch mechanism
Interior motion sensor
Remote handset
Liftgate latch mechanism
Keyless Vehicle Module
Keyless
Vehicle Module (KVM)
Remote Keyless Entry Module (RFA)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault and may also cause additional faults in
the vehicle being checked and/or the donor
vehicle.
NOTES:
If
© 2011-2026 Copyright www.rrevoque.org
