Range Rover Evoque: Terrain response messages

Messages relating to the Terrain response system are displayed in the message centre.

See 56, INSTRUMENT PANEL.

Most of the messages that appear will be for information only and require no driver intervention.

READ NEXT:

 Hill descent control

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd o

 Hdc operation

With HDC engaged, standard descent speed will not exceed 20km/h (12.4mph). While the green warning lamp is continuously illuminated, HDC target speed can be modified using the cruise control steer

SEE MORE:

 Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 303-882 Installer, Halfshaft Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - LHD AWD/RHD AWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. CA

 To erase all programming

For first time programming, ensure that the engine is switched off: 1. Ensure that the ignition is on (but with the engine switched off). 2. Press and hold the two outer HomeLink buttons. Keep the buttons pressed until the indicator lamp begins to flash (this will take approximately 20 second

© 2011-2025 Copyright www.rrevoque.org