Range Rover Evoque: Timing Chain
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
4.
5.
6.
7.
8. CAUTIONS:
Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.
Note the fitted position of the component prior to removal. Do not disassemble further if removed for access only
9.
Installation
1. CAUTION: Install a new friction washer.
2. CAUTIONS:
Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.
Make sure that these components are installed to the noted removal position.
Only tighten the bolts finger-tight at this stage.
3.
4. Torque: 10 Nm
5. Torque: 10 Nm
6. CAUTION: Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning. Torque: 72 Nm
7. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
8. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
READ NEXT:
Timing Cover
Special Tool(s)
303-021
Engine support bracket
JLR-303-1591
Lifting Bracket, Engine - Rear
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustratio
Valve Cover
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Engine - Removal and Installation
Removal
Special Tool(s)
205-857
Remover, Halfshaft
1. Refer to: Battery Tray (414-01 Battery, Mounting and Cables,
Removal and Installation).
2. Refer to: Air Conditioning (A/C) System Recovery, Evacu
SEE MORE:
Using the repair kit
Avoid skin contact with the
sealant
which contains natural rubber latex.
Do not unscrew the sealant bottle from
the receiver until it is empty, as
sealant will leak out.
If the tyre inflation pressure does not
reach 1.8 bar (26 lb/in²) within seven
minutes, the tyre may have suffered
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start the engine.
The keyless start backup can only be used
when the message Smart Key Not Found Refer
t
