Range Rover Evoque: Torque Converter Seal TD4 2.2L Diesel

Special Tool(s)

307-597
Installer, Torque Converter Seal

307-613
Holding Pins, Torque Converter

Removal

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Transmission - TD4 2.2L Diesel (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Removal).

4. CAUTIONS:

Be prepared to collect escaping oil.

Make sure that all openings are sealed.

• Special Tool(s): 307-613

5. CAUTION: Take extra care when removing the component, prevent damage to the mating faces.

Installation

1. CAUTIONS:

Extreme cleanliness must be exercised when handling this component.

Make sure that the mating faces are clean and free of foreign material.

Special Tool(s): 307-597

2. CAUTIONS:

Make sure that the mating faces are clean and free of foreign material.

Make sure the torque converter is fully located into the oil pump drive.

• Special Tool(s): 307-613

3. Refer to: Transmission - TD4 2.2L Diesel (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Installation).

4. Connect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

Torque Converter TD4 2.2L Diesel

Special Tool(s)

307-613
Holding Pins, Torque Converter

Removal

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Transmission - TD4 2.2L Diesel (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Removal).

4. CAUTIONS:

Be prepared to collect escaping oil.

Make sure that all openings are sealed.

• Special Tool(s): 307-613

Installation

1. CAUTIONS:

Make sure that the mating faces are clean and free of foreign material.

Make sure the torque converter is fully located into the oil pump drive.

• Special Tool(s): 307-613

2. Refer to: Transmission - TD4 2.2L Diesel (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Installation).

3. Connect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

Input Shaft Speed (ISS) Sensor TD4 2.2L Diesel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Transmission Fluid Pan - TD4 2 2L Diesel (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Removal and Installation).

4. CAUTION: Extreme cleanliness must be exercised when handling this component. Torque: 6 Nm

Installation

1. To install, reverse the removal procedure.

READ NEXT: