Range Rover Evoque: Touch Screen (TS)
Touch Screen Display (FCDIM)
The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Multifunction Display Module, for additional Diagnosis and Testing information refer to the relevant Diagnosis and Testing Section.
For additional information, refer to: Information and Entertainment System (415-01 Information and Entertainment System, Diagnosis and Testing).
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the warranty policy and procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component.
Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer-approved diagnostic system)
When performing voltage or resistance tests, always use a digital multimeter accurate to three decimal places and with a current calibration certificate. When testing resistance, always take the resistance of the digital multimeter leads into account
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests
Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
If diagnostic trouble codes are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals
Where an 'on demand self-test' is referred to, this can be accessed via the 'diagnostic trouble code monitor' tab on the manufacturers approved diagnostic system
The table below lists all diagnostic trouble codes (DTCs) that could be logged in the touch screen, for additional diagnosis and testing information refer to the relevant diagnosis and testing section. 415-00 or 415-01
READ NEXT:
Blind Spot
Monitoring Module (SODL/SODR)
Blind Spot Monitoring System Module (SODL/SODR)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a
Health and Safety Precautions
Introduction
Modern vehicles contain many materials and liquids which if not handled with
care can be hazardous to both personal
health and the environment. Also, many of the procedures associated wi
Solvents, Sealants and Adhesives
Solvents
WARNING: Always
handle all solvents, sealers and adhesives with extreme care. Some contain
chemicals or give off
fumes which can be dangerous to health. Always follow the manufacturers
in
SEE MORE:
Topping up the coolant
Never remove the filler cap
when the
engine is hot - escaping steam or
scalding water could cause serious
personal injury.
Antifreeze is highly inflammable. Do
not allow antifreeze to come into
contact with naked flames or other
sources of ignition (e.g. a hot engine)
- a fire may result.
Coolant antifreeze
Antifreeze is poisonous and
can be
fatal if swallowed - keep containers
sealed and out of the reach of
children. If accidental consumption is
suspected, seek medical attention
immediately.
If the fluid comes into contact with the
skin or eyes, rinse immediately with
plenty of water.
The
