Range Rover Evoque: Towing eyes

and rear The towing eyes at the front and rear of the vehicle are designed for on-road recovery only. If they are used for any other purpose, it may result in vehicle damage and serious injury.

The towing eyes are located behind panels in

The towing eyes are located behind panels in the bumpers. Panel design will vary depending on the vehicle specification. To use the towing eyes: 1. Front bumper - rotate the two fasteners 90 degrees counter clockwise. Pull the panel away from the front bumper.

2. Rear bumper - rotate the two fasteners 90 degrees counter clockwise. Pull the panel away from the rear bumper.

3. If the Dynamic pack is fitted, the exhaust finisher will also require removal before the towing eye can be used.

Installation of the panels is the reverse of removal.

before Remove the towing eye covers before driving off-road, to prevent damage or loss.

READ NEXT:

 Off-road recovery

If the towing eyes are to be used for off-road recovery, it is essential that off-road driver training covering recovery techniques is undertaken. Further information on off-road driver trainin

 Towing the vehicle on four wheels

If the vehicle battery is disconnected or disabled, do NOT attempt to tow the vehicle. Towing may result in serious damage to the transmission. The vehicle should NOT be towed on all four whee

 After towing on four wheels

1. Apply the parking brake. For vehicles with an automatic gearbox, apply the footbrake and then select Park position. 2. Switch off the ignition and remove the Smart Key from the vehicle. 3. Rem

SEE MORE:

 Restraints Control Module (RCM)

WARNINGS: TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE DEPLETED BEFORE REPAIRING OR REPLACING ANY AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) COMPONENTS. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT ONE MI

 Rear Wheelhouse Front Extension

Removal NOTE: The rear wheelhouse front extension is taken from the rear wheelhouse outer and is manufactured from mild steel. 1. The rear wheelhouse outer is replaced in conjunction with: Rear bumper cover Quarter panel Quarter glass Front inner quarter panel 2. For additional information r

© 2011-2025 Copyright www.rrevoque.org