Range Rover Evoque: Wheel Knuckle Rear Bushing
Special Tool(s)
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, Wheel Knuckle Bushing
LR-121
Hydraulic Cylinder 10t
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Remove the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3.
4.
5. CAUTION: Note the position of the component and mark the surrounding area to aid installation.
6. Remove the bushing.
Special Tool(s): LR-121, 204-620-02, 204-620-03
Installation
1. CAUTION: Make sure that the component is installed to the position noted on removal.
2. CAUTION: Make sure the correct special tool is used to install the bushings to the correct depth.
Install the bushing.
Special Tool(s): LR-121, 204-620-01, 204-620-02
3. Torque: 270 Nm
4. Torque: 110 Nm
5. Install the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
READ NEXT:
Rear Shock Absorber Vehicles With: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations sectio
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspensi
Spring Vehicles Without: Dynamic Suspension
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's i
SEE MORE:
Interior lights locations
Interior lights locations
1. Sun visor lamps. Illuminates when the
vanity mirror is opened.
2. Map reading lamps. Move a finger close to
(or touch) the relevant lens to switch
on/off.
Note: If you are wearing gloves, it may be
necessary to touch the lens to operate the
lamps.
3. Front int
Voice tutorial
To listen to a tutorial detailing the operation of
the Voice system:
- Briefly press the Voice button to start a
voice session.
- Wait for the tone to sound, then say Voice
tutorial.
Alternatively, the tutorial can be selected using
the touch screen, as follows.
- Select Setup from the touch
