Range Rover Evoque manuals

Range Rover Evoque: Changing a road wheel

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wheel changing / Changing a road wheel

Changing a road wheel
Changing a road wheel

1. Temporary spare wheel locking ring.

2. Temporary spare wheel retaining bolt.

3. Tool kit retaining bolt.

4. Jack.

5. Wheel brace.

should be After use, the tool kit should be returned to the under floor storage area and correctly stowed.
The spare wheel is heavy and if handled incorrectly may cause injury.
Use extreme caution when lifting or manoeuvring the wheels.
Always secure the spare wheel, or the removed wheel, in the correct position using the retaining bolt.

Always remove the temporary spare wheel before jacking the vehicle.

Note: Examine the jack occasionally, clean and grease the moving parts, particularly the screw thread, to prevent corrosion.

READ NEXT:

 Removing the temporary spare wheel

Remove the spare wheel prior to jacking the vehicle, to avoid destabilising the vehicle when raised. Do not use power tools to loosen the spare wheel. Doing so may damage the mechanism. 1.

 Temporary spare wheel

Always adhere to the instructions given on the temporary use spare wheel warning label. Failure to comply can be dangerous. When a temporary use spare wheel is fitted, drive with caution and r

 Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit. Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks. Before raising the vehic

SEE MORE:

 Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch. 1. Lift the locking lever and pivot the seatback forwards. 2. Press the front of the switch to power the seat forwards. 3. To return the seat, pivot the se

 Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD/M66 6-Speed Manual Transmission FWD

Removal CAUTIONS: Make sure that the wiring harness is not twisted or damaged on removal. Failure to follow this instruction may result in damage to the vehicle. Take extra care not to damage the wiring harness clips. NOTES: Some variation in the illustrations may occur, but the essential informa

© 2011-2025 Copyright www.rrevoque.org