Range Rover Evoque: Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.

If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.

If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.

READ NEXT:

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

 Manual transmission

Manual transmission Selection of reverse gear is prevented when the vehicle is travelling in excess of 24km/h (15mph). Never attempt to engage reverse gear while the vehicle is in forward mo

SEE MORE:

 Anti-Theft - Active

Anti-Theft - Active - Component Location COMPONENT LOCATION RH (right-hand) front door module RH front door latch mechanism Radio Frequency (RF) receiver RH rear door module RH rear door latch mechanism Interior motion sensor Remote handset Liftgate latch mechanism Keyless Vehicle Module

 Information and Message Center

Information and Message Center - Component Location COMPONENT LOCATION Information and Message Center - Overview OVERVIEW The message center is located in the instrument cluster, in a central position between speedometer and the tachometer. The 5 inch Thin Film Transistor (TFT) display can be cont

© 2011-2025 Copyright www.rrevoque.org