Range Rover Evoque: How it works

Viewing angles for driver and front seat passenger are such that neither can view the full display that the other is viewing. However, there is an optimum viewing angle of 30 degrees where no cross over of images can be perceived. From this point, the closer to screen centre or screen side edges that the viewer moves to, the more likely cross over of images is. During normal use of dual view, image cross over is unlikely.

Rear seat passengers may be able to see both

Rear seat passengers may be able to see both views when dual view is active.

READ NEXT:

 Dual view selection

When the ignition is switched on or the audio unit is turned on after being turned off, single view mode will be the default view. To select dual view, press the dual view hard key on the fascia s

 Dual view control menu

Dual view control menu 1. Select to cancel dual view and revert to the menu for the current video source (TV, DVD). Note: The preview screen will be deactivated if the vehicle is moving. 2. Se

 Dual view tv operation

If you would like to change the TV programme while the vehicle is moving, there are two methods available; 1. Press the dual view hardkey to display the control menu. Select an alternative channe

SEE MORE:

 Fender Apron Panel Front Reinforcement

Removal NOTES: The fender apron panel front reinforcement is manufactured from RP220 and mild steel. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The front side member and fender a

 Supervisor screen controls

Supervisor screen controls See 104, TOUCH SCREEN OVERVIEW. 1. Select rear media. 2. Current rear media display. 3. Left screen select. 4. Right screen select. 5. Settings screen. 6. Remote control lock. 7. Turns off the selected screen. 8. Turns off the selected system. 9. Audio source s

© 2011-2025 Copyright www.rrevoque.org