Range Rover Evoque: Battery - Removal and Installation
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Battery and Charging System / Battery, Mounting and Cables / Battery - Removal and Installation
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1.
2.
3. Torque: 25 Nm
4. Torque: 25 Nm
5.
6. Torque: 6 Nm
7. NOTE: If equipped.
Torque: 10 Nm
8.
9. Torque: 6 Nm
10. Torque: 6 Nm
11.
12.
13.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Battery Tray
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Battery
Generator and Regulator - GTDi 2.0L Petrol
Generator - Component
Location
COMPONENT LOCATION
Battery positive connection
LIN (local interconnect network) bus connection
Generator
Generator - Overview
OVERVIEW
A single self-exciting gener
SEE MORE:
Sensor blockage
If one of the sensors is completely obscured
the BSM system is automatically disabled, the
warning indicator dot is displayed in the
exterior mirror and the message BSM sensor
blocked appears in the message centre.
Note: Blockage testing is only initiated when
vehicle speed is above 32km/h (20
Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output
which must not be exceeded. An accessory
harness kit increasing output to 15 amp is
available from your Land Rover Dealer.
When a trailer electrica
© 2011-2025 Copyright www.rrevoque.org
