Range Rover Evoque: Glass Roof Panel Blind Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
All vehicles
1. NOTE: The step must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
3-door
2. NOTE: The procedure must be carried out on both sides. Refer to: B-Pillar Upper Trim Panel - 5-Door (501-05 Interior Trim and Ornamentation, Removal and Installation).
5-door
3. NOTE: The procedure must be carried out on both sides. Refer to: B-Pillar Upper Trim Panel - 5-Door (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. NOTE: The procedure must be carried out on both sides. Refer to: C-Pillar Upper Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
All vehicles
5. NOTE: The procedure must be carried out on both sides. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
6. Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).
7. NOTE: The step must be carried out on both sides.
8. NOTE: The step must be carried out on both sides.
9. NOTE: The step must be carried out on both sides.
10. NOTE: The step must be carried out on both sides.
11.
12.
13. NOTE: The step must be carried out on both sides.
14. NOTE: The step must be carried out on both sides.
15. NOTE: The step must be carried out on both sides.
16.
17. CAUTION: Do not use excessive force to release the headliner from the side retaining brackets.
NOTES:
Headliner shown removed for clarity.
Vehicles with glass roof panel only.
Release the headliner from the retaining brackets using a suitable plastic trim tool.
18. CAUTION: Extra care must be taken at this point, as the headliner is still retained by a locating clip at the rear and the 3 retaining clips at the front.
NOTE: This step requires the aid of another technician.
Lower the headliner for access.
19. NOTES:
Headliner shown removed for clarity.
This step requires the aid of another technician.
- Release the headliner from the 3 front retaining clips (1) and slide rear wards to detatch from the locating clip (2).
- Lower the headliner for access.
20. Torque: 3.5 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Rear Quarter Window Glass 5-Door
Removal
1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
2. Refer to: C-Pillar Upper Trim Panel (501-05 Interior Trim and
Ornamentation, Rem
Instrument Panel TD4 2.2L Diesel
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Descriptio
SEE MORE:
Power Flows
Operation of the transmission is controlled by the TCM which electrically
activates various solenoids to control the
transmission gear selection. The sequence of solenoid activation is based on
programmed information in the TCM memory
and physical transmission operating conditions such as vehicle
Replacing remote control batteries
Replacing remote control batteries
With the back of the remote control facing
upwards, use a coin or similar implement to
rotate the battery cover. Lift the cover off to
reveal the battery compartment. Remove the
old battery and, ensuring that the correct
polarity is maintained, insert a rep
