Range Rover Evoque: Opening and closing the bonnet

Opening and closing the bonnet
Opening and closing the bonnet

Opening

1. Pull the bonnet release lever, located in the left-hand front footwell.

2. Lift the bonnet safety catch lever, located below the centre point of the bonnet, then raise the bonnet.

Closing

retained Do not drive with the bonnet retained by the safety catch alone.

3. Lower the bonnet until the safety catch engages. Using both hands, press the bonnet down until the catches click. Check that both catches are engaged by trying to lift the front edge of the bonnet.

READ NEXT:

 Poisonous fluids

Fluids used in motor vehicles are poisonous and should not be consumed or brought into contact with open wounds. For your own safety, always read and obey all instructions printed on labels and co

 Used engine oil

Prolonged contact with engine oil may cause serious skin disorders, including dermatitis and cancer of the skin. Always wash thoroughly after contact. It is illegal to pollute drains, water co

 Engine compartment overview

Engine compartment overview 2.0L petrol engine 1. Brake/clutch fluid reservoir caps (beneath covers): A. Left-hand drive vehicles. B. Right-hand drive vehicles. 2. Engine oil filler cap. 5. O

SEE MORE:

 Rear Door Trim Panel

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Torque: 1.3 Nm 2. Torque: 6 Nm 3. Torque: 6 Nm 4. 5. 6. 7. NOTE: Do not disassemble further if the component is removed for access only. 8. Torque: 0.6 Nm 9. 10. Torque: 1 Nm 11. Installation 1. To install,

 Climate Control System - General Information

Climate Control Lubricants, Fluids, Sealers and Adhesives General Specification Capacities Refrigerant oil adding capacities for replacment parts NOTE: Rotate the A/C compressor shaft at least 6 to 8 turns when draining the refrigerant oil. Air Conditioning (A/C) System Recovery, Evacuation an

© 2011-2025 Copyright www.rrevoque.org