Range Rover Evoque: Rear Lower Arm FWD
Removal
NOTES:
LH illustration shown, RH is similar.
Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. NOTE: All wheel drive transmission illustrations shown, front wheel drive transmission is similar.
4. CAUTION: Note the fitted position of the special washer.
5.
6.
7. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. NOTE: This step is only required if previously removed.
2. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
3. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
4. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Support weight of vehicle on a jack at the rear hub.
5.
6. Torque: 175 Nm
7. CAUTION: Note the fitted position of the special washer.
8. Torque: 175 Nm
9. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
10. Check and if necessary, adjust the rear wheel alignment
READ NEXT:
Rear Suspension FWD
Component Location
Stabilizer link
RH (right-hand) spring and damper assembly
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Stub axle and locknut
Hub
Longitudinal li
Wheels and Tires
Wheel and Tire
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. NOTE: Ma
Vehicle Dynamic Suspension
Vehicle Dynamic Suspension - Component
Location
COMPONENT LOCATION
RH (right-hand) rear spring and damper assembly
RH rear height sensor
LH (left-hand) rear spring and damper assembly
LH rear he
SEE MORE:
Front Seat Cushion Cover Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correctly install
and care for the seat cover.
2.
3.
4. If required, follow the steps below
Fuel Tank and Lines - Diagnosis and Testing
Principles of Operation
For a detailed description of the fuel tank and lines systems, refer to the
relevant Description and Operation section in the
workshop manual. REFER to: (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol)
Inspection and Verification
WARNINGS:
Eye protection must be worn at all
