Range Rover Evoque manuals

Range Rover Evoque: Installing an isofix child seat

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Occupant safety / Installing an isofix child seat

Installing an isofix child seat
Installing an isofix child seat

To install an ISOFIX child seat:
1. Locate the ISOFIX locking mechanism.

2. Slide the child seat into the locking mechanism.

3. If an upper tether is fitted to the child seat, ensure it is properly secured to the upper tether anchorages on the rear of the seats.

Test the security of the child restraint. To do this, attempt to pull the restraint away from the vehicle seat and twist the restraint from side to side. Even if the restraint appears secure, you should still check the anchor points visually, to ensure correct attachment.

Note: Always ensure that if an upper tether is provided, it is fitted and tightened correctly.

READ NEXT:

 Tether anchorage points (Australia only)

WARNING: Child restraint anchorages are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts, ha

 Attaching tether straps

1. Install the child restraint securely in one of the rear seating positions. 2. Pass the tether strap over the seat back and beneath the head restraint. 3. Attach the tether strap hook to the tet

 Airbag supplementary restraint system (SRS)

Airbag supplementary restraint system (SRS) 1. Front passenger’s airbag 2. Curtain airbags 3. Side airbags 4. Knee-bolster airbag 5. Driver’s airbag Note: The general location of airbags f

SEE MORE:

 Roof Front Panel Vehicles With: Sliding Roof Opening Panel

Removal NOTES: The roof front panel is manufactured from mild steel. The 4 x screw in studs must be replaced in the installation of the roof front panel. 1. The roof front panel is replaced in conjunction with: Windshield Headliner Moonroof 2. For additional information relating to this repa

 Cylinder Block Components - 2.0L GTDi

Component Description Front crankshaft oil seal Front cover assembly Knock sensor - cylinders 1 and 2 Gasket - thermostat housing Thermostat Cylinder block Knock sensor - cylinders 3 and 4 Bolt (2 off) Bolt (3 off) Oil pump Gasket - oil pump inlet Oil pump filter and pick-up assembly

© 2011-2026 Copyright www.rrevoque.org