Range Rover Evoque: Pairing and connecting from your mobile phone
Note: The process of pairing and connecting your phone with the vehicle using the mobile phone, will vary depending on the type of mobile phone used.
1. Switch the ignition on and ensure that the touch screen is active.
2. From the home menu, select Phone.
3. A menu will appear. Select Search new.
4. Select Device to vehicle option.
Note: The vehicle’s Bluetooth® system is discoverable for only 3 minutes.
5. Using the mobile phone, search for Bluetooth® devices.
On some phones, this is referred to as new paired device. See your phone's operating instructions for further information.
6. When the vehicle's Bluetooth® system is discovered, follow the on-screen instructions. Select Yes when prompted, to confirm the pairing.
Either the phone or the vehicle system will ask for a PIN (Personal Identification Number). When prompted, enter a PIN of your choice and select OK to confirm.
7. Enter the same PIN into the other device.
8. Once your phone is paired and connected to the system, a confirmation message will be displayed before switching to the Digit Dial screen.
Note: Some mobile phones require the Bluetooth® pairing to be set as ‘authorised’ or ‘trusted’ in order to automatically connect. Please refer to your phone’s operating instructions for further information.
READ NEXT:
Pairing and connecting from the touch screen
1. Switch on your mobile phone’s Bluetooth®
connection. Make sure that your mobile
phone is in Bluetooth® discoverable mode,
sometimes referred to as find me mode
(see your phone’s operating
Changing the connected phone
Up to 10 mobile phones can be paired with the
vehicle in the same way. However, only one can
be connected and ready for use as a phone at
any one time.
To connect a different paired phone, follow
Touch screen icons
Connect. Use to send or accept
a call and access last 10 dialled
numbers.
Disconnect. Use to end or reject
a call.
No phone connected.
Phone signal strength indicator.
Phone battery l
SEE MORE:
Rear Inner Quarter Panel
Removal
NOTES:
The rear inner quarter panel is manufactured from mild steel.
The rear inner quarter panel is unpicked from the inner quarter panel, it is not
serviced separately.
There are NVH components on this panel, they are not serviced on the new panel.
If damaged, new components will
be re
General program (special programs off)
This program is compatible with all
on and off-road conditions. If not
already active, it should be selected
before driving on surfaces which are similar to
a hard road surface. Dry cobbles, tarmac, dry
wooden planks, etc., all fall into this category.
This program should be selected once th
