Range Rover Evoque: Rear loadspace
Never allow passengers to
travel in
the loadspace under any
circumstances. All vehicle occupants
should be seated correctly and wear a
seat belt at all times when the vehicle
is in motion.
Always ensure that objects carried
within the vehicle are secured
properly.
To remove the loadspace cover: 1. Release the two straps from the pins on the tailgate.
2. Pull the cover rearwards to release the retaining brackets on the edges of the cover from the pins on the loadspace side trim.
Never place objects on top of
the
loadspace cover. During an accident
or sudden manoeuvre, loose objects
Installation of the cover is the reverse of removal.
Storing the cover:
Do not store the loadspace
cover
loose in the vehicle.
1. Remove the loadspace cover.
2. Fold the rear seats forward.
3. Position the cover vertically in the vehicle approximately where the upright rear seat backrests are normally. The top surface of the cover must be facing forwards with the retaining brackets at the top.
4. Locate the retaining brackets onto the side trim pins.
5. Return the rear seats to the upright locked position.
READ NEXT:
Roof racks
A loaded roof rack can reduce
the
stability of the vehicle, particularly
when cornering and during cross
winds.
Driving off road with a loaded roof
rack is not recommended.
Fit only a roof ra
Luggage anchor points
Luggage anchor points
All items
carried in the luggage area
should be properly secured.
1. Bag hooks.
- The bag hooks should only be used to
secure light items such as shopping
bags.
2. Lo
SEE MORE:
System fault
If a fault with one of the radar sensors is
detected, an amber warning indicator dot is
displayed in the exterior mirror and the
message BSM not available is displayed in the
message centre.
Note: Even if the detected fault only affects the
radar sensor on one side of the vehicle, the
whole s
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener or entry gate,
ensure the area is clear. This will
prevent potential harm or damage as
the gate o
