Range Rover Evoque: Rear seat access (coupe models)

The front seats tilt and power slide forwards for entry to and exit from the rear seats. Operation is controlled by a lever and switch.

1. Lift the locking lever and pivot the seatback

1. Lift the locking lever and pivot the seatback forwards.

2. Press the front of the switch to power the seat forwards.

3. To return the seat, pivot the seatback until it locks into its previous position, then press and hold the rear of the switch to power the seat rearwards until it locks into position.

READ NEXT:

 Rear seats

 Folding and raising the rear seats

Folding and raising the rear seats The split fold rear seat of 5 door models can be folded completely, or partially at 60/40 split, to accommodate loads and still retain seating for passengers.

 Rear seat head restraints

Adjust the head restraint so that the top of the head restraint is above the centre line of the head. An incorrectly adjusted head restraint increases the risk of death or serious injury in the

SEE MORE:

 Rear Side Member Section

Removal NOTES: The rear side member section is manufactured from RP260, with its inner reinforcement manufactured from DP600. The rear side member section is cut from the rear side member service panel, the section also includes the upper and lower side extensions. 1. In this procedure, to make s

 Electric Power Assisted Steering Module (EPAS)

Steering Gear (PSCM)  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.  NOTES: If the control

© 2011-2026 Copyright www.rrevoque.org