Range Rover Evoque: Replacing remote control batteries
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Heating and ventilation / Replacing remote control batteries
Replacing remote control batteries
With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compartment. Remove the old battery and, ensuring that the correct polarity is maintained, insert a replacement 3.3 volt, CR1/3N battery. Replace the cover and rotate it to lock it closed.
READ NEXT:
Additional remote controls
A maximum of three controls can be
programmed to each vehicle. Contact your
Land Rover dealer to purchase additional units
and have them programmed to your vehicle.
Cup holders and storage
Cup holders and storage
1. Glovebox.
2. Inside the glovebox is a drop down storage
area for the Owner’s Handbook pack.
3. Cubby box.
4. Sliding top to reveal cup holders.
Do not drink, or u
SEE MORE:
Differential Support Insulator
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Support the rear differential using a transmission jack.
3. CAUTION: Mark the components to aid
installation.
Discard the bolts.
4.
Installation
1. Torque: 35 Nm
2. CAUTIONS:
Make sure that
Charging or replacing the vehicle battery
If the vehicle battery should require charging,
the battery must be removed from the vehicle.
Consult your Dealer/Authorised Repairer.
Battery disconnection,
removal and
replacement should be carried out only
by qualified personnel. Consult your
Dealer/Authorised Repairer.
Used batteries
© 2011-2026 Copyright www.rrevoque.org
