Range Rover Evoque: Sensor care
When washing the vehicle do
not aim
high pressure water jets directly at the
sensors. Do not use abrasive materials
or hard/sharp objects to clean the
sensors. Only use approved vehicle
shampoo.
The sensors should be kept clean to maintain
accuracy and performance.
READ NEXT:
Note: Physical controls are referred to as hard
keys. Virtual buttons on the touch screen are
referred to as soft keys.
Screen options will vary depending on vehicle
specification and set-up.
T
Always run the engine during
prolonged
use of the touch screen. Failure to do so
may discharge the vehicle battery,
preventing the engine from starting.
Avoid spilling or splashing liquids onto
SEE MORE:
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Rear Wheel Bearing
JLR-204-810
Installer, Rear Wheel Bearing
General Equipment
Copper Hammer
Hydrau
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution (EBD) system.
Stop the vehicle as soon as safety permits.
If the message CHECK BRAKE FLUID is
dis
© 2011-2026 Copyright www.rrevoque.org
