Range Rover Evoque: Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension

Special Tool(s)

JLR-204-804
Lever, Wheel Knuckle

General Equipment

• Transmission jack
• Wooden Block

Removal

CAUTIONS:

Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

LH illustration shown, RH is similar.

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

3. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

4.

5. WARNING: Make sure that a new nut is installed.

Torque:

Bolts 10 Nm
nut 60 Nm

6. Torque: 110 Nm

7. Torque: 270 Nm

8.

• General Equipment: Transmission jack
• General Equipment: Wooden Block

9. Torque: 175 Nm

10. CAUTION: Note the fitted position of the component prior to removal.

11. Install the Special Tool(s): JLR-204-804

12.

13. CAUTION: Take extra care not to damage the wiring harnesses.

14. Torque: 32 Nm

15. Torque: 32 Nm

16. NOTES:

Do not disassemble further if the component is removed for access only.

Only if fitted.

Torque: 10 Nm

Installation

1. NOTE: Make sure that the component is installed to the noted removal position. To install, reverse the removal procedure.

Rear Suspension

Principles of Operation

For a detailed description of the Suspension System and operation, refer to the relevant Diagnosis and Testing section of the workshop manual.

REFER to: Suspension System (204-00 Suspension System - General Information, Diagnosis and Testing).

READ NEXT: