Range Rover Evoque: Sitting in the correct position
The driver
and front seat passenger
must not ride with the seat fully
reclined.
Do not adjust
the seat while the
vehicle is moving.
The seat, head restraint, seat belt and airbags, all contribute to the protection of the user.
Correct use of these components will give you greater protection. Therefore, you should always observe the following points:
1. Sit in an upright position with the base of your spine as far back as possible and the seatback reclined no more than 30 degrees.
2. Do not move the driver's seat too close to the steering wheel. Ideally, a minimum distance of 254mm (10in) is recommended between the breastbone and the steering wheel airbag cover. Hold the steering wheel in the correct position, with your arms slightly bent.
- Adjust the head restraint so that the top of the head restraint is above the centre line of the head.
- Position the seat belt so that it is mid-way between your neck and your shoulder. Fit the strap tightly across your hips, not across your stomach.
- Ensure that your driving position is comfortable and enables you to maintain full control of the vehicle.
READ NEXT:
Memory seats
Front seat positions can be saved to vehicle
memory.
Once you have adjusted the power operated
driver’s seat and the exterior mirrors, the
vehicle can memorise the settings for future
use. See
Easy entry/exit
When Easy entry/exit is configured, the driver’s
seat will automatically lower when the ignition
is switched off and the door release lever is
used. Upon returning to the vehicle, when the
drive
Head restraints
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
SEE MORE:
Exterior Lighting - Component Location
COMPONENT LOCATION
Instrument cluster
Hazard flasher switch
Rain/Light sensor
Rear height sensor (Xenon headlamps only)
Side turn signal indicator lamp
Headlamp leveling control module
CJB (central junction box)
Reverse lamp switch
Front height sensor (Xenon headlamps only)
Stop lamp swi
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mounted in the engine compartment. The engine weight is kept
to a minimum by using aluminum for
the cyli
