Range Rover Evoque: Steering Linkage
Tie Rod End
Special Tool(s)
205-754A
Splitter, Ball Joints
Removal
NOTE: RH illustration shown, LH is similar.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3.
4. CAUTIONS:
Make sure that the ball joint ball does not rotate.
Discard the nut.
5. CAUTION: Make sure that the ball joint seal is not damaged. Special Tool(s): 205-754A
6.
7. CAUTION: Note the number of turns when removing the tie rod end to aid installation.
Installation
1. CAUTION: Make sure that the tie rod end is installed with the same number of turns as when removed.
2. WARNING: Make sure that a new nut is installed.
CAUTION: Make sure that the ball joint ball does not rotate. Torque: 133 Nm
3. Torque: 100 Nm
4. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
5. Using only four wheel alignment equipment approved by Land Rover, check and adjust the wheel alignment.
Steering Gear Boot
Removal
NOTE: LHD illustration shown, RHD is similar
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Tie Rod End (211-03 Steering Linkage, Removal and Installation).
3. NOTES:
Note the position of the components prior to removal.
Discard the retaining clips.
Installation
1. NOTES:
Make sure that these components are installed to the noted removal position.
Install new retaining clips.
2. Refer to: Tie Rod End (211-03 Steering Linkage, Removal and Installation).
Steering Linkage
Torque Specifications
* New nut must be installed
READ NEXT:
Steering Column
Steering Column - Component Location
Upper column
Steering wheel
Intermediate shaft
Steering Column - Overview
The steering column consists of an intermediate shaft, the upper column and
the st
Steering Column Switches
Torque Specifications
Steering Column Multifunction Switch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Removal of the windshield wiper switch assembly is identic
SEE MORE:
System
- Button feedback: Soft key confirmation
tone on or off.
- Clock adjust: Select 12 or 24 hour clock.
Set current time. Select Date to change the
date, or to alter the date format.
Select Set, to store new settings.
Note: The clock can also be adjusted from
the touch screen time display.
- Ho
Voice
- Command list: View the categories and the
acceptable voice commands.
Select an Information button to view
alternative function commands.
- Voicetags: View the categories. Select a
category to manage the voicetags for the
chosen system. See 140, VOICETAGS.
- Operating guide: View brief Voice
