Range Rover Evoque: Anti-Lock Control - Stability Assist
Accelerometer
Removal
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
Vehicles with automatic transmission
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. Torque: 9 Nm

Vehicles with manual transmission
3. Refer to: Floor Console (501-12 Instrument Panel and Console,
Removal and Installation).
4.

5.

6. Torque: 9 Nm

Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
READ NEXT:
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The step must be carried out on both sides.
LH illustration shown, RH is similar.
3. NOTES:
The step m
DRIVE CLUTCHES
Multiplate Drive or Brake Clutch - Typical
Input shaft
Main pressure supply port
Piston
Cylinder - External plate carrier
Clutch plate assembly
Baffle plate
Diaphragm spring
Output shaft
Bearing
Dynamic pressure equalisation chamber
Piston chamber
Lubrication channel
Th
© 2011-2026 Copyright www.rrevoque.org
