Range Rover Evoque: Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed.

- The brake pedal is pressed.

- Speed falls below 30km/h (18mph).

- Neutral, Park or Reverse gear is selected on vehicles with automatic transmission.

- Dynamic Stability Control is operating.

- The difference between the actual and set speed is too great.

- The vehicle reaches a speed of 170km/h (105.6mph).

- The accelerator pedal is used to accelerate beyond the set speed for too long a period.

Cruise control will switch off and clear the memory when: - The ignition system is switched off.

- A fault occurs. The cruise control system will switch off and cannot be used until the fault is cleared.

READ NEXT:

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

 Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs. The vehicle is not designed for cornering at the sa

SEE MORE:

  Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission FWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 307-594 Installer, Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Front Halfshaft RH - FWD (205-04 Front Drive Halfshafts, Removal and Installation). 3. CAUTIONS: Make sure that

  Manual Transmission FWD

Component Location COMPONENT LOCATION Manual transmission Selector lever assembly Overview OVERVIEW The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford in Cologne, Germany. The transmission is a highly compact 4 shaft design, incorporating the front final drive gear.

© 2011-2026 Copyright www.rrevoque.org - 0.0035