Range Rover Evoque: Blower Motor LHD AWD/LHD FWD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES: Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. NOTE: The recirculation blend door must be closed in order for the removal of the recirculation blend door housing. Activate recirculation.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).
5.
6.
7.
8. Torque: 10 Nm
9.
10.
11.
12.
13. Special Tool(s): 412-140
14.
15. CAUTION: Make sure that the special tool is correctly located.
NOTE: With assistance remove the component.
Installation
1.
2.
3. To install, reverse the removal procedure.
READ NEXT:
Blower Motor RHD AWD/RHD FWD, RHD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essenti
Climate Control Assembly
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: LH illustration shown, RH is similar.
NOTE: The procedure must be carried out on both
sides.
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to c
SEE MORE:
Oil check preparation
Prior to checking the oil level ensure that:
- The vehicle is on level ground.
- The engine oil is cold.
Note: If it is necessary to check the oil level
when the engine is hot, switch off the engine
and let the vehicle stand for 5 minutes to allow
the oil to drain back into the sump. Do not st
Topping up the engine oil
Your vehicle warranty may be
invalidated if damage is caused by
using oil that does not meet the
required specification.
Failure to use an oil that meets the
required specification could cause
excessive engine wear, a build up of
sludge and deposits, and increase
pollution. It could also le
