Range Rover Evoque: Drive selector fails to elevate
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Drive selector fails to elevate
If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal.
If the selector still fails to elevate, even if there is no obstruction, a fault in the system is indicated. The selector can still be used in the lowered position. Ensure that P is selected before engine switch off. Have the fault rectified at the earliest opportunity.
READ NEXT:
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
Manual transmission
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo
Gear shift indicator
The gear shift indicator
illuminates
briefly at the recommended gear
change point (upshift).
The shift indicator will not illuminate while
Cruise control is active and is not being
overridden
SEE MORE:
Cleaning the exterior
Remove any heavy deposits of
mud and
dirt with a hose before washing the
vehicle.
Never aim a hose water jet directly at
the engine air intake, heater air intakes,
body seals or at any components which
may be damaged.
Do not use a high pressure washer or
steam cleaner in the engine
compa
Cleaning after off-road driving
Ensure that the areas around
air intakes
and the front grille are clean and clear of
debris. Pay particular attention to the
lower grille and radiator. Failure to do
so may cause the engine to overheat,
leading to severe engine damage.
Ensure that the vehicle underside is cleaned as
soon
© 2011-2026 Copyright www.rrevoque.org - 0.0033
