Range Rover Evoque: Front/Rear Door Latch
Front Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Exterior Front Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1 2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Rear Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Exterior Rear Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
2.
3. Torque: 1.2 Nm
4. NOTE: Loosen the bolt, but do not fully remove.
Torque: 3.2 Nm
5. Torque: 7 Nm
6. CAUTION: Take extra care not to damage the component.
7. NOTE: Do not disassemble further if the component is removed for access only.
8.
Installation
1. To install, reverse the removal procedure.
Liftgate Latch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 25 Nm
3. Torque: 25 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Exterior Front/Rear Door Handle
Exterior Front Door Handle
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always co
Wipers and Washers - Component Location, System Operation and Component
Description
Component Location
COMPONENT LOCATION - SHEET 1 OF 2
Central Junction Box (CJB)
Integrated Control Panel (ICP)
Rain/Light sensor (if fitted)
Right tailgate actuator (upper)
Rear wiper motor
Le
SEE MORE:
Front Halfshaft LH
Special Tool(s)
205-857
Remover, Halfshaft
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft constant velocity (CV) joints do not over art
Engine Emission Control - GTDi 2.0L Petrol
Emission Control -
Component Location
COMPONENT LOCATION
Intake manifold
Bolt (8 off)
Crankcase ventilation hose
Oil separator
Gasket
Camshaft cover
Lower clean air inlet duct
Upper clean air inlet duct
Camshaft cover vent hose
Air cleaner housing
Engine Emission Control -
Overview
OVER
